5 Steps To A Killer Finish: Part 2
Support Workpieces – While Spraying. Most pieces can be sprayed horizontally, which is the ideal arrangement, so the top of your work support should be oriented in that manner. The support should have a stable base and hold the work at a comfortable height, usually 650cm – 750cm (26” – 30”) for spraying.
5 Steps To A Killer Finish: Part 1
In this two-part blog, I will share my 5 interdependent steps required to consistently produce quality finishes. Why not jam it all into one article, you ask? I wish I could, however, there is far too much material to cover on one blog. So, in this blog I will cover the first 3 steps: Spray equipment cleaned and lubricated Piece prepared Environment set for success (1st part) 1. Spray equipment cleaned and lubricated. The importance of a clean gun and air system cannot be overemphasized, as you cannot possibly achieve success unless you start out that way. And by properly lubricating your